Lamp!
Made this lamp out of an old 1940’s radio transmitter power output meter, to sit on top of the modular. Edit January 2021: built another similar one 🙂
Category: Uncategorized
Uncategorized
Kassutronics Slope
This is similar to half a Make Noise Maths, so I built a couple. All through hole, straightforward, no issues and not much to say about the build…haven’t done a through hole build in a…
DIY tips Eurorack Synth DIY Through hole Uncategorized
Updating Division 6 Business Card sequencer firmware to V2
This is available as a PCB and Panel from Division 6. It’s a useful little Eurorack sketchpad, and the recently released V2 firmware adds a bunch of new features. When I built the module, I…
Eurorack SMD Synth DIY Uncategorized
MI Tides build
This board is of similar complexity to MI Clouds and Rings (the biggest challenge being the STM and the DAC in terms of fine pitch soldering), and I wasn’t expecting any major issues building it,…
Effects Eurorack Synth DIY Uncategorized
Testing out Beat Repeat
A quick test before it goes into the rack. 4 3340 VCOs, one AMing a VCA. homebrew Electric Druid LFO into O_c running Hemisphere firmware in ASR mode, Ladder filter, 8 step seq, ST modular…
DIY tips SMD Synth DIY Uncategorized
Unpacking 0603/0805 etc passives from cut strips
If you do any SMD synth DIY work, you’re going to have to unpack tiny components from cut strips. In doing so, you’re also going to experience pinging them across the room by mistake, never…